Figure 3-176: Configuring Vpn Pptp Server - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
3.3.3.5.2 Configuring PPTP Server
The device can act as a Point-to-Point Tunneling Protocol Server (PPTP Server), accepting
PPTP client connection requests.
To configure PPTP:
1. Click the PPTP item (Configuration tab > Data menu > VPN submenu > PPTP); the
following page appears:
2. Under the 'Server' group, perform the following:
a. Select the 'Enabled' check box to enable the PPTP feature. Note that checking
this box creates a PPTP server, but does not define remote users.
b. Click the Click here to create VPN users link to define remote users that are
granted access to your home network (see ''Creating VPN Users'' on page 267).
c. Click the Advanced button to display additional parameters and configure the
following:
♦
♦
♦
♦
3. Under the 'Remote Address Range' group, in the 'Start IP Address' and 'End IP
Address' fields, specify the range of IP addresses that are granted by the PPTP server
to the PPTP client.
Note:
Version 6.2

Figure 3-176: Configuring VPN PPTP Server

In the 'Max Idle Time to Disconnect in Seconds' field, specify the amount of
idle time (during which no data is sent or received) that should elapse before
the device disconnects a PPTP connection.
Select the 'Authentication Required' check box to enable PPTP to use
authentication, and then select the algorithms the server may use when
authenticating its clients.
Select the 'Encryption Required' check box to enable PPTP to use
encryption, and then select the algorithms the server may use when
encrypting data.
From the 'MPPE Encryption Mode' drop-down list, select the Microsoft Point-
to-Point Encryption mode.
The server settings must be compatible with the client settings, described in
''Configuring Network Connections'' on page 287.
265
3. Web-Based Management
February 2011