Figure 3-135: Adding A New Group - AudioCodes Mediant 800 MSBG User Manual

4. Click New Group
Note:
5. Configure the annex, line rate, and pair numbers as provided by your ISP, and then
click OK.
Note:
6. Connect the SHDSL cabling as required. SHDSL wire pairs are numbered 0 to 3,
according to the following RJ-45 connector pinouts:
7. Click the SHDSL Line Settings link to refresh the status display and wait for the line
to synchronize. Ensure that the group status displays "RUNNING" before proceeding
to the next step.
SIP User's Manual
to add a new SHDSL wire.

Figure 3-135: Adding a New Group

When using EFM, only one wire-pair group can be defined.
Central Office (CO) termination mode is available for diagnosis only; the
device cannot be used as a full-featured DSLAM or LTU.
Figure 3-136: SHDSL RJ-45 Wire Pinouts
236
Mediant 800 MSBG
Document #: LTRT-12804