Figure 2-18: Configured Ports For Incoming Sip; Figure 2-19: Traffic Matching Rule For Received Sip Signaling Traffic - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
d. Define the TCP and UDP ports, and then click OK; the following page appears
displaying the configured ports.
a.
b.
c.
The configured incoming and outgoing SIP ports are shown below:

Figure 2-19: Traffic Matching Rule for Received SIP Signaling Traffic

e. Click OK.
Version 6.2

Figure 2-18: Configured Ports for Incoming SIP

Click OK again.
Perform steps 2b through 2e to configure ports for outgoing SIP packets.
Under the 'Operation' group, select the 'Set Tx Class Name' check box, and
then from the corresponding drop-down list, select the traffic shaping class
'VOIP Tx', which you defined for Rx packets (in ''Defining VoIP Tx Shaping
Class'' on page 33).
37
2. Configuration Concepts
February 2011