SIP User's Manual
To configure the SNMP community strings:
1.
Open the 'SNMP Community String' page (Maintenance tab > System menu >
Management submenu > SNMP submenu > SNMP Community String).
2.
Configure the SNMP community strings parameters according to the table below.
3.
Click the Submit button to save your changes.
4.
To save the changes to flash memory, see ''Saving Configuration'' on page 336.
To delete a community string, select the Delete check box corresponding to the community
string that you want to delete, and then click Submit.
Table 3-8: SNMP Community String Parameters Description
Parameter
Community String
Trap Community String
[SNMPTrapCommunityString]
Version 6.2
Figure 3-36: SNMP Community String Page
Read Only [SNMPReadOnlyCommunityString_x]: Up to five
read-only community strings (up to 19 characters each). The
default string is 'public'.
Read / Write [SNMPReadWriteCommunityString_x]: Up to
five read / write community strings (up to 19 characters each).
The default string is 'private'.
Community string used in traps (up to 19 characters).
The default string is 'trapuser'.
Description
79
3. Web-Based Management
February 2011