AudioCodes Mediant 800 MSBG User Manual page 122

Parameter
Description
[IPGroup_Description]
Proxy Set ID
[IPGroup_ProxySetId]
SIP Group Name
[IPGroup_SIPGroupName]
Contact User
[IPGroup_ContactUser]
SRD
[IPGroup_SRD]
SIP User's Manual
routing to the IP Group is done.
Notes:
This field is available only if the SBC or IP-to-IP application
is enabled. (The IP-to-IP application will be supported in the
next applicable release.)
Currently, the GATEWAY IP Group type can only be
configured using the IPGroup ini file parameter.
Brief string description of the IP Group.
The value range is a string of up to 29 characters. The default
is an empty field.
The Proxy Set ID (defined in ''Configuring Proxy Sets Table'' on
page 126) associated with the IP Group. All INVITE messages
destined to this IP Group are sent to the IP address associated
with the Proxy Set.
Notes:
Proxy Set ID 0 must not be selected; this is the device's
default Proxy.
The Proxy Set is applicable only to SERVER-type IP
Groups.
The SIP Request-URI host name used in INVITE and
REGISTER messages sent to the IP Group, or the host name
in the From header of INVITE messages received from the IP
Group. If not specified, the value of the global parameter,
ProxyName (see ''Configuring Proxy and Registration
Parameters'' on page 136) is used instead.
The value range is a string of up to 100 characters. The default
is an empty field.
Note: If the IP Group is of type USER, this parameter is used
internally as a host name in the Request-URI for Tel-to-IP
initiated calls. For example, if an incoming call from the device's
T1 trunk is routed to a USER-type IP Group, the device first
creates the Request-URI (<destination_number>@<SIP Group
Name>), and then it searches the user's internal database for a
match.
Defines the user part for the From, To, and Contact headers of
SIP REGISTER messages, and the user part for the Contact
header of INVITE messages that are received from the IP
Group and forwarded by the device to another IP Group.
Notes:
This parameter is applicable only to USER-type IP Groups.
This parameter is overridden by the 'Contact User'
parameter in the 'Account' table (see ''Configuring Account
Table'' on page 133).
The SRD (defined in Configuring SRD Table on page 114)
associated with the IP Group.
The default is 0.
Note: For this parameter to take effect, a device reset is
required.
122
Mediant 800 MSBG
Description
Document #: LTRT-12804