Figure 3-298: Start Software Upgrade Wizard Screen - AudioCodes Mediant 800 MSBG User Manual

Warning:
Notes:
To load files using the Software Upgrade Wizard:
1. Stop all traffic on the device using the Graceful Lock feature (refer to the warning
bulletin above).
2. Open the 'Software Upgrade Wizard' (Maintenance tab > Software Update menu >
Software Upgrade Wizard); the 'Software Upgrade Wizard' page appears.

Figure 3-298: Start Software Upgrade Wizard Screen

SIP User's Manual
The Software Upgrade Wizard requires the device to be reset at the end of
the process, which may disrupt traffic. To avoid this, disable all traffic on the
device before initiating the wizard, by performing a graceful lock (see Saving
and Resetting the Device).
•
Before upgrading the device, it is recommended that you save a copy of
the device's configuration settings (i.e., ini file and data file) to your PC. If
an upgrade failure occurs, you can then restore your configuration
settings by uploading the backup file to the device. For saving and
restoring configuration, see ''Backing Up and Loading Configuration File''
on page 344.
•
Before you can load an ini or auxiliary file, you must first load a cmp file.
•
When you activate the wizard, the rest of the Web interface is
unavailable. After the files are successfully loaded, access to the full Web
interface is restored.
•
If you upgraded your cmp and the "SW version mismatch" message
appears in the Syslog or Web interface, then your Software Upgrade Key
does not support the new cmp version. Contact AudioCodes support for
assistance.
•
If you use the wizard to load an ini file, parameters excluded from the ini
file are assigned default values (according to the cmp file running on the
device), thereby, overriding values previously defined for these
parameters.
•
You can schedule automatic loading of these files using HTTP/HTTPS
(refer to the Product Reference Manual).
342
Mediant 800 MSBG
Document #: LTRT-12804