AudioCodes Mediant 800 MSBG User Manual page 823

SIP User's Manual
Parameter
Web/EMS: Reorder Tone
Duration [sec]
[TimeForReorderTone]
Web: Time Before Reorder Tone
[sec]
EMS: Time For Reorder Tone
[TimeBeforeReorderTone]
Web: Cut Through Reorder Tone
Duration [sec]
[CutThroughTimeForReOrderT
one]
Web/EMS: Enable Comfort Tone
[EnableComfortTone]
[WarningToneDuration]
Web: Play Ringback Tone to Tel
EMS: Play Ring Back Tone To
Tel
[PlayRBTone2Tel]
Version 6.2
For Analog: The duration (in seconds) that the device plays a
Busy or Reorder tone duration before releasing the line.
The valid range is 0 to 254. The default is 0 seconds.
Typically, after playing a Reorder/Busy tone for the specified
duration, the device starts playing an Offhook Warning tone.
For Digital: The duration (in seconds) that the CAS device plays a
Busy or Reorder Tone before releasing the line.
The valid range is 0 to 254. The default value is 10.
Notes:
The selection of Busy or Reorder tone is performed according
to the release cause received from IP.
This parameter is also applicable for ISDN when
PlayBusyTone2ISDN is set to 2.
This parameter can also be configured per Tel Profile, using
the TelProfile parameter).
The delay interval (in seconds) from when the device receives a
SIP BYE message (i.e., remote party terminates call) until the
device starts playing a Reorder tone to the FXS phone.
The valid range is 0 to 60. The default is 0.
Note: This parameter is applicable only to FXS interfaces.
Defines the duration (in seconds) of the Reorder tone played to
the PSTN side after the IP call party releases the call, for the Cut-
Through feature. After the tone stops playing, an incoming call is
immediately answered if the FXS is off-hooked (for analog
interfaces) or the PSTN is connected (for digital interfaces).
The valid values are 0 to 30. The default is 0 (i.e., no Reorder
tone is played).
Note: To enable the Cut-Through feature, use the
DigitalCutThrough (for CAS channels) or CutThrough (for FXS
channels) parameters.
Determines whether the device plays a Comfort Tone (Tone Type
#18) to the FXS/FXO endpoint after a SIP INVITE is sent and
before a SIP 18x response is received.
[0] Disable (default)
[1] Enable
Note: This parameter is applicable to FXS and FXO interfaces.
Defines the duration (in seconds) for which the Off-Hook Warning
Tone is played to the user.
The valid range is -1 to 2,147,483,647. The default is 600.
Notes:
A negative value indicates that the tone is played infinitely.
This parameter is applicable only to analog interfaces.
Enables the play of the ringback tone (RBT) to the Tel side and
determines the method for playing the RBT.
[0] Don't Play = RBT is not played.
[1] Play on Local = RBT is played to the Tel side of the call
823
12. Configuration Parameters Reference
Description
February 2011