Figure 3-116: Wan Access - AudioCodes Mediant 800 MSBG User Manual

SIP User's Manual
device. For more information, refer to ''Configuring SHDSL WAN Interface'' on page
234.
Note:
3.3.3.2.1 Configuring Ethernet WAN Interface
For Ethernet WAN interface, you can configure the device to use one of the following
methods for connecting to the Internet:
Manual IP address Ethernet connection
Automatic IP address Ethernet connection
Point-to-Point Protocol over Ethernet (PPPoE)
Point-to-Point Tunneling Protocol (PPTP)
Layer 2 Tunneling Protocol (L2TP)
The type of connection should be as instructed by your ISP. If you do not have an Internet
connection or if you want to disable all existing connections, select 'No Internet Connection'
from the 'Connection Type' drop-down list.
Once you have defined the basic WAN connection type (listed above and described in the
procedure below), you can configure advanced settings such as the WAN port's physical
attributes (link speed and duplex mode) and routing. The advanced configuration
parameters can be accessed using one of the following methods:
Clicking the Click here for Advanced Settings link as described in Step 3 below
Clicking the Edit
Connections'' on page
To configure the Internet (WAN) connection:
1. Open the 'Settings' page (Configuration tab > Data menu > WAN Access submenu
> Settings); the following page appears:
Version 6.2
The supported WAN connection methods depend on the installed Software
Upgrade Key. For installing a Software Upgrade Key, refer to ''Loading
Software Upgrade Key'' on page 339.
icon in the Connections list, as described in ''Editing Existing
328

Figure 3-116: WAN Access

225
3. Web-Based Management
February 2011