Remove The Low Voltage Power Supply - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
5. Remove the service door. See
6. Loosen the 4 thumbscrews and remove the front plate.
7. Pull the tray forward and out of the projector until the wire terminals are exposed.
8. Disconnect all of the wires that are attached to the LVPS and disconnect the stand by power supply AC
input connector.
9. Remove the tray with the LVPS and the standby power supply from the projector.
10. Disconnect the standby power supply inline connector behind the card cage.
11. Loosen the 2 captive screws on the cap plate and then remove it.
12. Pull the standby power supply harness out of the projector through the cap plate opening.
13. Remove the clip holding the stand by wire to the LVPS,
14. Remove the two screws from the standby power supply bracket and then remove the bracket and set it
aside.
15. Remove the standby power supply.
3.18

Remove the Low Voltage Power Supply

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the service door. See
3-16
Remove the Service Door on page
Remove the Top Lid on page
Remove the Service Door on page
3-8.
3-4.
3-8.
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)