Section 3: Parts and Module Replacement
6. Remove the yellow notch filter. See
7. Remove the three screws that secure the contrast aperture to the IOS.
8. Slide the aperture out along the slotted tracks inside the IOS.
3.32.2 Remove the Light Sensor Module
The light sensor module, mounted to the side of the IOS, is orientated to sample the light coming through the
fold mirror.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the front skin. See
5. Disconnect the harness from the light sensor module.
6. Remove the 2 screws that secure the sensor to the IOS. NOTE: The middle screw is used to adjust light
tolerances.
When reinstalling the light sensor module, recalibrate the footLambert (fL) readings for minimum and
maximum power. See the Solaria One or Solaria One+ user manuals.
3-34
Yellow Notch Filter (YNF) on page
Remove the Top Lid on page 3-4.
Remove the Front Skin on page
3-37.
3-4.
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)