Remove The Anode Lamp Firewall; Replace The Standby Power Supply - Christie Solaria One Service Manual

3.16

Remove the Anode Lamp Firewall

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the lamp and place it into a protective case and reinstall the cathode nut. See
Lamp on page
5. Remove the safety shield. See
6. Remove the 2 screws from the top firewall bracket and then remove the bracket.
7. Remove the 2 screws holding the firewall to the cathode blower assembly.
8. Disconnect the fan1 harness from the firewall.
9. Lift the firewall up and out of the top of the projector.
3.17

Replace the Standby Power Supply

The standby power supply is installed next to the low voltage power supply (LVPS).
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Slide the card cage forward to access the standby power supply inline connector. See
Cardcage on page
4. Remove the top lid. See
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Remove the Top Lid on page
3-10.
Remove the Safety Shield on page
3-25.
Remove the Top Lid on page
Section 3: Parts and Module Replacement
3-4.
3-9.
3-4.
Remove the Existing
Remove the
3-15