Add The Lamp To The Lamp History - Christie Solaria One Service Manual

3. Remove the plastic packing material from the lamp.
4. Remove the cathode nut from the lamp before removing it from the case.
5. For CDXL-14 or CDXL-16 lamps:
a. Install the lamp extension nut on the cathode clamp. To provide access to the locking screw on the
extension nut, rotate the extension nut until the locking screw faces upward toward the projector lid.
b. Tighten the cathode screw (4) with a hex key. See diagram page 3-12.
c. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the cath-
ode clamp.
d. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back of
the reflector assembly. To help guide the lamp into position, insert your right index and middle finger
through the back of the reflector and thread the cathode end of the lamp into the extension nut. When
threading the lamp into the extension nut, make sure the anode wire does not hit the reflector or the
UV filter.
e. Tighten the extension nut screw.
f. Move to step 7.
6. For the CDXL-21S1 lamp:
a. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back of
the reflector assembly. Insert your right index and middle finger through the back of the reflector and
guide the lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector
b. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the cath-
ode clamp.
c. Tighten the cathode screw (4) with a hex key. See diagram page 3-12.
7. Align the ring terminal on the anode wire (2) with the mounting position ensuring the crimped side of the
wire is facing out. Tighten the anode screw (1). See diagram page 3-12. NOTE: Route anode lead away
from nearby metal surfaces.
8. Close the lamp access door and tighten the 2 thumbscrews.
9. Close the firewall door and tighten the 2 thumbscrews.
10. Close and lock the rear access door. NOTE: Ensure the hex key is placed back into its holder before
closing the rear access door.
11. Add the lamp to the lamp history. See

3.14.3 Add the Lamp to the Lamp History

1. Connect the projector to AC power and then turn the projector on.
2. Tap Menu > Advanced Setup > Lamp Change Wizard.
3. Tap Next.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Section 3: Parts and Module Replacement
Add the Lamp to the Lamp History on page 3-13.
3-13