Remove The Low Voltage Power Supply; Remove The Projector Feet - Christie CP2215 Service Manual

Parts and Module Replacement
5. Remove the safety shield. See
6. Remove the service door. See
7. Remove the top bracket by loosening the captive screw.
8. Remove the AC power cord from the bottom of the standby power supply.
9. Remove the power supply harness from the 6 P-clips on the back of the rear skin.
10. Remove 1 screw from the clip clamp holding the harness to the rear skin.
11. Remove the harness from the P-clip on the base of the projector.
12. Disconnect the standby inline connector.
13. Remove the standby power supply.

Remove the Low Voltage Power Supply

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the service door. See
5. Loosen the 4 captive screws securing the LVPS cover.
6. Disconnect the 4 DC harnesses.
7. Disconnect the LVPS harness connected to the relay.
8. Remove the tray with the LVPS from the projector.
9. Remove the 4 screws that secure the LVPS to the mounting plate.
10. Disconnect the line ground and neutral connectors.

Remove the Projector Feet

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Prop up the appropriate end of the projector, or shift the projector off of the table or pedestal to
create enough clearance.
To remove the front feet, 6in. (15 cm) of clearance is required. To remove the rear feet, 9in.
(23cm) of clearance is required.
32
Remove the Safety Shield
Remove the Exhaust Panel Skin
Remove the Top Lid on page 22.
Remove the Exhaust Panel Skin
on page 27.
on page 26.
on page 26.
CP2215 Service Manual
020-101226-03 Rev. 1 (10-2015)