Remove The Imcb; Remove The Lens Mount - Christie Solaria One Service Manual

3.27

Remove the IMCB

This procedure is applicable to the Solaria One
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Disconnect the IMCB cable connector.
6. Loosen the captive screw.
7. Slide the IMCB toward the operator side of the projector to disengage the locking pins.
8. Lift the IMCB through the top of the projector.
3.28

Remove the Lens Mount

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lens surround.
4. Remove the lens. See
5. Remove the top lid. See
6. Remove the front skin. See
7. Remove the plate between the lens mount and the blower intake.
8. Remove the light engine blower assembly. See
9. Disconnect the IMCB connectors.
10. Remove the 4 lens mount screws. It might be necessary to adjust the horizontal or vertical position of the
lens to access the screws.
11. Disengage the IMCB harness assembly from the cable clamps and remove the assembly through the front
of the projector.
12. Remove the lens mount.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
+
projector only.
Remove the Top Lid on page
Remove the High Security and Light Engine Lid on page
Remove the Lens on page
Remove the Top Lid on page
Remove the Front Skin on page
Section 3: Parts and Module Replacement
3-4.
3-14.
3-4.
3-4.
Remove the Light Engine Blower (Fan 4) on page 3-32.
3-5.
3-23