Replace The Light Engine - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
7. Remove the top 2 screws and the attached clamps from the UV filter housing.
8. Slowly loosen the bottom screw until you can remove the UV filter.
9. To reinstall the UV filter, perform the steps in reverse order. Make sure that the filter is installed with the
arrow indicator on the edge of the filter pointing towards the lamp.
3.25

Replace the Light Engine

The light engine can be removed as an assembly with the harnesses still attached. Removing the light engine
this way reduces the risk of damage to other projector components.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the lens. See
4. Remove the top lid. See
5. Remove the high security lid. See
3-20
A Top screws
B Bottom screw
Wear gloves and an electro-static bracelet when working with the light engine.
Remove the Lens on page
Remove the Top Lid on page
Remove the High Security and Light Engine Lid on page
3-14.
3-4.
Solaria One/Solaria One
3-5.
+
Service Manual
020-101039-02 Rev. 1 (06-2013)