Christie Solaria One Service Manual page 39

6. Loosen the two thumbscrews and open the lamp access door.
7. Remove the screw securing the anode wire. It is recommended that you use a 5 mm magnetized ball driver.
8. For CDXL-14 or CDXL-16 lamps:
a. Loosen the extension nut screw (1).
b. Hold the cathode end of the lamp with your right hand and the anode end with your left hand and care-
fully turn the lamp with your right hand so that it unthreads from the extension nut. Make sure the
lamp does not contact the reflector or the UV filter.
c. With your left hand guide the cathode end of the lamp out of the reflector, on an angle through the
lamp access door.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Section 3: Parts and Module Replacement
3-11