Remove The Light Engine Blower (Fan 4); Remove The Fan Pack (Fans 5, 6, 7, And 8); Remove The Low Voltage Power Supply Fan (Fan 9) - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement

3.31.4 Remove the Light Engine Blower (Fan 4)

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Disconnect the harness.
6. Remove the 3 screws securing the intake duct.
7. Remove the intake duct.
8. Remove the 2 screws securing the light engine blower.

3.31.5 Remove the Fan Pack (Fans 5, 6, 7, and 8)

caught in fan blades.
The fan pack is located directly behind the air filter on the front of the projector and consists of four fans. If one
fan fails, the entire fan pack must be replaced.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the cardcage air intake filter cover and filter. See
5. Remove the front skin. See
6. Remove the high security lid. See
7. Disconnect the four inline connectors from the fan power harnesses.
8. Pull the release located in the high security compartment to release the fan pack.
9. Remove the fan pack.
10. Remove a fan and then install its replacement with the airflow directional arrow facing the direction of the
airflow. NOTE: Use needle nose pliers to pull the rubber isolators through the fan mounting holes.

3.31.6 Remove the Low Voltage Power Supply Fan (Fan 9)

caught in fan blades.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the service door. See
5. Loosen the 4 screws securing the LVPS cover.
6. Disconnect the fan harness.
3-32
Remove the Top Lid on page
Remove the High Security and Light Engine Lid on page
Use caution when working in and around fan assemblies. Fingers can get
Remove the Top Lid on page
Remove the Front Skin on page
Remove the High Security and Light Engine Lid on page
Use caution when working in and around fan assemblies. Fingers can get
Remove the Top Lid on page
Remove the Service Door on page
3-4.
3-4.
Inspect the Card Cage Filter on page 3-1.
3-4.
3-4.
3-8.
Solaria One/Solaria One
3-5.
3-5.
+
Service Manual
020-101039-02 Rev. 1 (06-2013)