Adjust Red/Green/Blue Formatter Convergence - Christie Solaria One Service Manual

2.7.3

Adjust Red/Green/Blue Formatter Convergence

Remove all jewelry before you adjust convergence.
NOTE: Do not apply excessive force on the adjustment screws. This might cause the convergence adjustment
to become misaligned after you remove the adjustment tool.
The Red and Green Formatters are identical in design and adjuster function, but Red cannot be adjusted due to
space limitations. The Blue formatter board physical design is different, but the adjustment functions are the
same. The vertical and twist adjustments work together on the horizontal axis.
The physical layout of the Formatter boards determines the behavior of the Twist and Vertical adjustments:
• The vertical adjustment screw and twist adjustment screw interact with each other such that if one is turned
in the opposite direction of the other, the twist is affected.
• If both screws are turned equal amounts in the same direction, the image moves vertically.
• The horizontal adjustment screw is independent of the vertical and twist adjustments.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Vertical and Twist
2
Screws 1 and 2
1
Light Engine Rear View - Heat Sink Hidden
Adjust Blue and Green Channels Only
Screen/Screw
1
N/A
N/A
Section 2: Adjust the Image
Horizontal
3
Screw 3
3
2
N/A
N/A
N/A
N/A
N/A
N/A
2-13