3: Parts And Module Replacement; Inspect The Card Cage Filter - Christie Solaria One Service Manual

3 Parts and Module Replacement
When you order replacement parts, provide this information found on the product license label on the rear of
the projector.
• Projector Model
• Projector Serial Number
• Manufacture Date
3.1

Inspect the Card Cage Filter

without the filter installed.
You should check the condition of the card cage air filter monthly.
Clean or replace the card cage air filter sooner if you are operating the
projector in a dusty or dirty environment. The filter is located on the
left side of the projector behind the air filter cover.
1. Loosen the 2 captive screws on the bottom of the filter cover.
2. Pull the cover out and down.
3. Slide the air filter out and inspect it.
If the filter appears dirty and you cannot see through it, replace it
with a new paper filter, or clean it if it is a washable filter. See
Clean a Washable Filter, on page 3-3
If the filter appears clean, continue to step 4.
4. Replace the air filter with the airflow indicator facing toward the projector.
5. Install the air filter cover by inserting the 2 bottom tabs and then pushing the cover closed.
6. Tighten the 2 captive screws.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Use only high efficiency Christie approved filters. Never operate the projector
for cleaning instructions.
3-1