Remove The Light Engine Fan (Fan 3) - Christie Solaria One Service Manual

7. Disconnect the cathode blower fan harness.
8. Remove the lamp adjust cable plate with the flexible shafts through the top of the projector.
9. Loosen the 3 thumbscrews securing the cathode blower assembly to the center structure.
10. Remove the cathode blower assembly through the top of the projector.
11. Remove the 4 screws holding the bracket plate and duct.
12. Remove the 2 screws holding the blower to the duct.

3.31.3 Remove the Light Engine Fan (Fan 3)

caught in fan blades.
The light engine intake fan draws filtered air through the front air filter.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Pull the cardcage outward to access the fan connectors. See
5. Remove the service door. See
6. Loosen the 2 captive screws securing the filter access door and then remove the filter access door.
7. Loosen the 2 captive screws securing the fan mounting plate to the center structure.
8. Push the fan and its mounting plate backward until they are released from the stand-offs. Remove the fan
and mounting plate.
When re-installing the fan and mounting plate, align the slots on the mounting plate with the stand-offs
located inside the projector. The fan airflow must be directed toward the light engine compartment.
9. Disconnect the number three fan harness.
10. Lift the fan up and away from the rubber isolators.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Use caution when working in and around fan assemblies. Fingers can get
Remove the Top Lid on page
Remove the Service Door on page
Section 3: Parts and Module Replacement
3-4.
Remove the Cardcage on page 3-25.
3-8.
3-31