Yellow Notch Filter (Ynf); Remove The Illumination Optic System - Christie Solaria One Service Manual

3.32.5 Yellow Notch Filter (YNF)

The YNF is located in the light path just after the contrast aperture.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the front skin. See
5. Remove the screw from the yellow notch filter cover and then remove the cover.
6. Loosen the thumb screw inside the yellow notch filter connecting it to the IOS.
7. Remove the two hex screws that secure the yellow notch filter to the IOS. If necessary, loosen the center
nut.
8. Carefully pull the filter out of the IOS.
When reinstalling the yellow notch filter, recalibrate MCGD and green primary. See
Color Calibration, on page
3.32.6

Remove the Illumination Optic System

UV HAZARD! Always wear protective safety clothing and a face shield when perform-
ing service with the safety shield removed and a lamp installed.
The IOS is a magnesium frame that holds the light engine. The light tube and most optical components are
fastened to the IOS. All components except the second fold mirror can be removed on their own; therefore, the
need to replace the IOS is low.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the light engine lid. See
5. Remove the light engine blower. See
6. Remove the light engine. See
7. Remove the reflector assembly. See
8. Remove the lamp adjust. See
9. Remove the 2 screws that secure the firewall that separates the lamp housing from the light engine.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
Remove the Top Lid on page
Remove the Front Skin on page
2-6.
Remove the Top Lid on page
Remove the High Security and Light Engine Lid on page
Remove the Light Engine Blower (Fan 4) on page
Replace the Light Engine on page 3-20.
Remove the Reflector Assembly on page
Remove the Lamp Adjust Assembly on page
Section 3: Parts and Module Replacement
3-4.
3-4.
3-4.
3-19.
3-18.
Yellow Notch Filter
3-5.
3-32.
3-37