Cardcage; Remove The Cardcage - Christie Solaria One Service Manual

4. Remove the side and rear projector skins. See
Rear Skin on page
5. Remove the 2 screws that secure the AC line filter to the bracket.
6. Disconnect the 2 harnesses from the 220V AC line filter.
3.30

Cardcage

Only Christie authorized service technicians should open the high security lid or access the electronics inside
the card cage.
When replacing the card cage, you must replace the anti-tamper label on the side of the cardcage

3.30.1 Remove the Cardcage

The cardcage module consists of the PIBS1, PIBS1 faceplate board, ICP, Christie IMB, and backplane.
Note: When replacing the cardcage, you must replace the anti-tamper label on the side of the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the high security lid. See
5. Remove the light engine blower. See
6. Reach into the top of the projector and disconnect the 3 light engine harnesses and the backplane harness:
a. Press both latches on the sides of the cable connectors with equal pressure.
b. Pull the cable connectors outward with even pressure. Do not use a twisting motion to disconnect the
cable connectors.
7. Remove the card cage surround.
8. Remove the 5 screws that secure the cardcage.
9. Remove the fire alarm interlock jumper.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
3-7.
Remove the Top Lid on page
Remove the High Security and Light Engine Lid on page
Remove the Light Engine Fan (Fan 3) on page
Section 3: Parts and Module Replacement
Remove the Exhaust Panel Skin on page 3-9
3-4.
and Remove the
3-5.
3-31.
3-25