Removing The Low Voltage Power Supply; Removing The Projector Feet - Christie CP2208 Service Manual

4. Loosen the two captive screws at the bottom of the card cage air filter cover.
5. Pull the cover out and down from the projector housing.
6. Remove the card cage. See
7. Disconnect the standby power supply inline connector.
8. Remove the two screws from the standby power supply bracket and then remove the bracket
and set it aside.
9. Remove the standby power supply.

Removing the low voltage power supply

1. Turn the projector off and then disconnect it from AC power.
2. Remove the top lid. See
3. Remove the service door. See
4. Loosen the four thumbscrews to remove the front plate, and then disconnect the fan from the
front plate.
5. Disconnect all of the wires that are attached to the LVPS.
6. Remove the LVPS and the standby power supply.
7. Disconnect the standby power supply cable.
8. Remove the four screws that secure the LVPS to the mounting plate.
9. Remove the screw securing the cable clamp.

Removing the projector feet

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. When the cooling fans stop, turn the projector off and then disconnect it from AC power.
3. Prop up the appropriate end of the projector, or shift the projector off of the table or pedestal to
create enough clearance.
To remove the front feet, 6in. (15 cm) of clearance is required. To remove the rear feet, 9in.
(23cm) of clearance is required.
4. Remove the rear skin to remove the rear feet or remove the front skin to remove the front feet.
See Removing the rear skin
5. Hold the top nut with a ratchet and then turn the locking nut on the foot to remove it.
6. Remove the foot.
CP2208 Service Manual
020-101917-01 Rev. 1 (11-2015)
Removing the card cage
Removing the top lid
Removing the service door
on page 37 or Removing the front skin
Parts and Module Replacement
on page 54.
on page 33.
on page 38.
on page 34.
46