Section 3: Parts and Module Replacement
3.32.4 Remove the Fold Mirror
NOTICE: Wear gloves when you handle the fold mirror.
Fold Mirror 1 is accessed from the front left-corner of the projector. The alignment screws are positioned along
the top of the light tube, which allows them to be easily adjusted.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid. See
4. Remove the side skin. See
5. Remove the contrast aperture. See
6. Remove the light sensor module and move it aside. See
7. Loosen the 2.5mm locking hex screw and remove the 2 2.5mm hex screws that secure the fold mirror to
the bracket.
8. Remove the fold mirror.
When reinstalling the fold mirror, make that the reflective surface faces inwards. Also, you must recali-
brate MCGD. See the Solaria One or Solaria One+ user manuals.
3-36
Remove the Top Lid on page
Remove the Exhaust Panel Skin on page
Remove the Contrast Aperture on page
A
A
Hex Screw (1 of 2)
B
2.5mm Locking Hex Screw
3-4.
3-9.
3-33.
Remove the Light Sensor Module on page
B
Solaria One/Solaria One
3-34.
+
Service Manual
020-101039-02 Rev. 1 (06-2013)