Adjust Horizontal Boresight - Christie Solaria One Service Manual

Section 2: Adjust the Image
3. Loosen the set screw (B).
4. Turn the vertical cap screw (A) 1/8 of a turn counter-clockwise.
5. Adjust both left and right horizontal adjusters by half the number of turns, in the opposite direction of the
vertical adjust. For example, if the vertical adjust cap screw was turned 1/8 of a turn, the left and right
horizontal cap screws should be turned 1/16 of a turn in the opposite direction.
6. Check the screen each time an adjustment is made. If the quality of the projected image has degraded, turn
the vertical adjust cap screw 1/8 of turn clockwise. Ensure the left and right horizontal adjusters are
adjusted equally in the opposite direction to correct axial focus. NOTE: The 1/8 of a turn is a suggestion
only and can be less if needed; however, it should never be exceeded. Always compensate both left and
right horizontal adjustments according to the vertical adjustment.
7. Check the image after each adjustment. Continue to make adjustments until both top and bottom are
equally sharp. To make sure the lens is in the same relative position, adjust the left and right horizontal
adjusters in the opposite direction at the same time.
8. When the top and bottom of the image are equally in focus lock the set screw to hold it in position.
Recheck the image.
9. If additional adjustment is required, see
10. Replace the lens surround.
2.4

Adjust Horizontal Boresight

focused uniformly on the screen by aligning the projector to the screen and focusing the lens.
When adjusting boresight, you must maintain the boresight distance from the lens to the
prism plane set by Christie. For example, when you move the top screw outward, turn the
bottom two boresight screws to maintain the overall distance.
2-4
A Cap Screw - Adjusts top and bottom boresight
B Set Screw - Locks or unlocks the cap screw
A boresight adjustment should only be made when the image cannot be
A
Adjust Horizontal Boresight on page
B
2-4.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)