Clean A Washable Filter - Christie Solaria One Service Manual

5. Loosen the 2 captive screws on the cap plate and then remove it.
6. Slide the air filter out and inspect it.
If the filter appears dirty, replace it with a new paper filter, or clean it if it is a washable filter. See
Washable Filter, on page 3-3
If the filter appears clean, continue to step 7.
7. Insert the air filter with the airflow indicator facing toward the projector.
8. Install the cap plate and tighten the 2 captive screws.
9. Install the service panel and then tighten the 2 screws.
10. Install the top lid.
3.3

Clean a Washable Filter

If the amount of dirt on the filter is minimal, use a vacuum or compressed air to remove it. If you use
compressed air, the air must move through the filter in the opposite direction of the air flow indicator on the
side of the filter.
WARNING
cause an electrical short and damage the projector.
1. Hold the filter on an angle under warm running water so the water flows through the filter in the opposite
direction of the air flow indicator on the side of the filter.
2. Rinse the filter thoroughly.
3. Submerge the filter for a minimum of 30 minutes in a container of warm water and two tablespoons of
mild detergent or liquid dish soap.
If the filter is extremely dirty, move the filter from side to side occasionally, or remove the excess dirt by
brushing both sides of the filter with a soft brush.
4. Rinse the filter thoroughly by holding it on an angle under cool running water. The air flow arrow on the
side of the filter should face down.
5. Repeat steps 3 and 4 if the filter still appears dirty.
6. Shake the filter over a container until most of the water is removed.
7. Place the filter on its edge on a flat, stable surface and allow it to dry thoroughly.
8. To confirm that the filter is dry, place it over a dry paper towel and shake it. If the paper towel remains dry,
the filter can be installed in the projector.
9. Record the date the filter was cleaned.
10. Replace the filter following the instructions for the specific filter. See
page 3-1 or
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
for cleaning instructions.
The installation of a filter that has not been allowed to dry completely can
Inspect the Light Engine Compartment Filter, on page
Section 3: Parts and Module Replacement
Inspect the Card Cage Filter, on
3-2.
Clean a
3-3