Section 3: Parts and Module Replacement
3.4
Remove the Top Lid
1. Loosen the seven screws that secure the top lid to the projector
2. Lift the lid up from the rear of the projector.
3.5
Remove the Front Skin
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the top lid
4. Remove the cardcage intake air filter cover. See
5. Remove the lens surround.
6. Remove the 4 screws that secure the skin to the projector structure.
7. On a Solaria One projector, remove the set screws from the horizontal and vertical lens adjustment knobs
and then remove the knobs.
8. Remove the 3 screws from the front skin and the 1 screw behind the filter cover.
9. Pull the front skin forward to remove it.
3-4
See
Remove the Top Lid on page
.
.
3-4.
Inspect the Card Cage Filter on page
Solaria One/Solaria One
3-1.
+
Service Manual
020-101039-02 Rev. 1 (06-2013)