Remove The Projector Intelligence Board - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
10. Pull up the release screw on the top of the cardcage and then slide the cardcage out along the guides.
11. Tilt the cardcage up and out to remove it.

3.30.2 Remove the Projector Intelligence Board

The PIBS1 is located in the cardcage on the operator side of the projector. It is the main controller for
alternative content.
• The marriage status light on the PIBS1 lights up when the high security lid is unlocked. To remarry the pro-
jector, see Activate Marriage in the Solaria One or Solaria One
• The system files (for examples, serial number, channel setting, hours, and so on) are stored on three modules:
the PIBS1, ICP, and TPC.
• All of the internal processor components have fixed IP addresses. This simplifies board configuration, as
well as component swapping between projectors.
When boards are replaced, the system stores a copy of the latest software version on the projector so that it can
be selected through the TPC and updated.
Note: When replacing the projector intelligence board, you must replace the anti-tamper label on the side of
the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the card cage surround.
4. Remove the 8 card cage faceplate screws.
5. Remove the card cage faceplate by the handles.
6. Disconnect the communication cable between PIBS1 and PIBS1 faceplate board.
7. Remove the rear support bracket between the PIBS1 and Christie IMB.
8. Remove the 4 screws from the HDMI A Left and HDMI B Right connectors.
9. Remove the 2 screws securing the PIBS1 to the front faceplate.
When reinstalling the PIBS1 and PIBS1 faceplate board you must perform Marriage so you can continue to
play encrypted content. See Activate Marriage in the Solaria One or Solaria One
3-26
+
user manuals.
+
user manuals.
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)