Replace The Lamp; Remove The Existing Lamp - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement
5. Pull the safety shield (A) up and outward from the locking tabs.
3.14

Replace the Lamp

EXPLOSION HAZARD. Wear authorized protective clothing whenever the lamp door is open
and when handling the lamp. Never twist or bend the quartz lamp body. Use the correct watt-
age lamp supplied by Christie. 3) Ensure those within the vicinity of the projector are also
wearing protective safety clothing including a full face shield, Kevlar gloves, and a ballistic
nylon jacket. 4) Never attempt to remove the lamp when it is hot. The lamp is under pressure
when hot and may explode, causing personal injury, death, or property damage. Allow the
lamp to cool completely before replacing it.

3.14.1 Remove the Existing Lamp

1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Put on your protective clothing and face shield.
4. Insert the key in the lock on the lamp door, turn the key, and then open the lamp door. Do not place heavy
objects on the open lamp door.
5. Loosen the 2 thumbscrews and open the firewall door.
3-10
1)Lamp replacement must be performed by a qualified service technician. 2)
Improper installation of the lamp can damage the projector.
A
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)