Christie Solaria One Service Manual page 49

6. Remove the 2 screws that secure the light engine cover (A).
7. Remove the light engine blower. See
8. Remove the light dump.
a. Disconnect the douser cable.
b. Loosen the captive screw securing the light dump and then lift the light dump up and out of the projec-
tor.
9. Disconnect the LVDS cables from the backplane:
a. Press both latches on the sides of the cable connector with equal pressure.
b. Pull the cable connector outward with even pressure. Do not use a twisting motion to disconnect the
cable connector.
Note: When replacing the LVDS cables, the This Side Up label on the connector must face outward.
Twisting or pulling the connector with unequal pressure can permanently damage it.
10. Remove the LVDS cables from the harness clips holding them to the center structure.
+
Solaria One/Solaria One Service Manual
020-101039-02 Rev. 1 (06-2013)
A
Remove the Light Engine Blower (Fan 4) on page
Section 3: Parts and Module Replacement
3-32.
3-21