Remove The Christie Imb; Remove The Backplane - Christie Solaria One Service Manual

Section 3: Parts and Module Replacement

3.30.5 Remove the Christie IMB

The Christie IMB is located in the cardcage on the operator side of the projector.
Note: When replacing the Christie IMB, you must replace the anti-tamper label on the side of the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the card cage surround.
4. Remove the 8 card cage faceplate screws.
5. Remove the card cage faceplate by the handles.
6. Remove the Gen Lock, Synch Out and LTC Out, and AES 3 faceplate connections.
7. Remove the rear support bracket between the PIBS1 and Christie IMB.
8. Remove the 2 screws securing the Christie IMB to the faceplate.
When reinstalling the Christie IMB you must perform Marriage so you can continue to play encrypted con-
tent. See Activate Marriage in the Solaria One or Solaria One

3.30.6 Remove the Backplane

The backplane is located at the back of the cardcage. The PIBS1, IMB, and ICP board are connected directly to
the backplane.
Note: When replacing the backplane, you must replace the anti-tamper label on the side of the cardcage.
1. Turn the lamp off and cool the projector for at least 15 minutes.
2. Turn the projector off and then disconnect it from AC power.
3. Remove the card cage. See
4. Remove the 8 screws securing the cardcage faceplate to the cardcage.
5. Remove the cardcage faceplate with the Christie IMB and PIBS1 and set them aside.
6. Remove the ICP. See
3-28
Remove the Cardcage on page
Remove the Integrated Cinema Processor on page
+
user manuals.
3-25.
3-27.
Solaria One/Solaria One
+
Service Manual
020-101039-02 Rev. 1 (06-2013)