Install The New Lamp - Christie Solaria One User Manual

g. With the lamp removed, visually inspect the reflector and clean if necessary.
2
1
9. Remove the new lamp from the protective case.
10. Loosen the cathode screw and remove the cathode nut from the lamp.

15.4.2 Install the New Lamp

NOT over-tighten. DO NOT stress the glass in any way. Check leads. Ensure the anode (+)
lead between the lamp and igniter is well away from any projector metal, such as the reflector
or fire wall.
1. Remove the tape from the ends of the protective case.
2. Remove the plastic packing material from the lamp.
3. Remove the cathode nut from the lamp before removing it from the case.
4. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back of the
reflector assembly. Insert your right index and middle finger through the back of the reflector and guide the
lamp onto the cathode clamp. Be careful not to hit the lamp against the reflector.
5. Thread on and hand-tighten the cathode nut. Ensure the smooth portion of the nut is against the cathode
clamp.
6. Tighten the cathode clamp (4) with a hex key.
15-4
3
1
2
3
4
5
6
Handle the lamp by the cathode/anode end shafts only, never the glass. DO
Anode Terminal
Anode Wire
Reflector
Cathode Screw
Cathode Nut
Cathode Clamp
4
5
6
Solaria One User Manual
020-100841-02 Rev. 1 (11-2012)