Managing Lamp Information; Creating A New Lamp File - Christie CP2208 User Manual

Managing lamp
information
Learn how to set up and work with a lamp.
This section provides information and procedures for optimizing lamp performance. Optimizing lamp
performance is recommended to make sure you receive the brightest, most uniform image possible for
the life of the lamp.

Creating a new lamp file

Define the lamp used in the projector.
1. Select Menu > Advanced Setup > Lamp Power / LiteLOC Setup.
2. Complete these fields.
Field
Power%
Enable LiteLOC
Light Meter - Set
Target
Amps
Volts
Watts
~fL or ~cd/m2
Hours
Intensity
3. Select Save As.
4. Enter a name for the lamp file in the Filename field.
5. Select OK.
CP2208 User Guide
020-101916-03 Rev. 1 (12-20120)
Copyright © 2020 Christie Digital Systems USA, Inc. All rights reserved.
Description
The percentage of power to supply to the lamp.
Enables or disables LiteLOC
™
that increases the power level to maintain lamp brightness as the
lamp ages.
Enables LiteLOC
long as possible. The Light Meter value is an arbitrary unit of measure,
not lumens or fL.
Lamp current in amperes.
Lamp voltage in volts.
Lamp power in watts.
Approximate Foot Lamberts reading on the light sensor. This assumes
a calibration was performed.
Number of hours the current lamp has operated.
The current light sensor reading in arbitrary units-of -measure and
does not represent actual lumens or fL.
. LiteLOC
™ ™
™ and maintains the current brightness level for as
is a power control algorithm
41