Remove New Lamp From Protective Cover; Install New Lamp - Christie CP2000 Setup Manual

Section 4: Maintenance
3. Handling by the cathode end only, unscrew the lamp from the rear connector and carefully remove
from the projector. Immediately place the lamp inside the protective cover (saved from previous
installation) and seal it in a heavy carton on the floor where it cannot fall or be bumped.
Handle box with extreme caution - the lamp is hazardous even when packaged. Dispose
of lamp box according to local area safety regulations.
4. With the lamp removed, visually inspect the reflector for dust. Clean if necessary, as described in
4.3 Maintenance and

REMOVE NEW LAMP FROM PROTECTIVE COVER

1. Remove tape, knurled nut and locking star washer (if present) securing the lamp within its cover.
2. Handling at the ends only, extract the lamp from the cover. Set aside the protective cover for re-use
in your next lamp disposal or for warranty return of an expired lamp.

INSTALL NEW LAMP

Handle by the cathode/anode end shafts only, never the glass. Do not over-tighten.
Do not stress the glass.
1. With protective clothing and shield on, insert the threaded cathode (-) end of the lamp into the
negative lamp connector nut located in the rear of the lamp compartment and screw in fully
(Figure 4-1 Install Bulb/Left). Hand-tighten only.
2. Rest the anode (+) end of the lamp on the lamp cradle (Figure 4-1 Install Bulb/Right) and slip the
positive lamp connector over the bulb end.
4-8
WARNING
Cleaning.
CAUTION
F 4-1 I
IGURE NSTALL
B
ULB
CP2000 Setup Guide
020-100070-01 Rev. 1 (10/08)