Install The New Lamp - Christie CP2215 Quick Start Manual

g. With the lamp removed, visually inspect the reflector and clean if necessary.
8. Remove the new lamp from the protective case.
9. Loosen the cathode screw and remove the cathode nut from the lamp.

Install the New Lamp

Handle the lamp by the cathode/anode end shafts only, never the glass. DO NOT over-
tighten. DO NOT stress the glass in any way. Check leads. Make sure the anode (+) lead
between the lamp and igniter is well away from any projector metal, such as the reflector or
fire wall. Failure to comply could result in minor or moderate injury.
1. Remove the tape from the ends of the protective case.
2. Remove the plastic packing material from the lamp.
3. Remove the cathode nut from the lamp before removing it from the case.
4. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the
back of the reflector assembly. Insert your right index and middle finger through the back of
CP2215 Quick Start Guide
020-101295-01 Rev. 1 (11-2013)
A Anode Terminal
B Anode Wire
C Reflector
D Cathode Screw
E Cathode Nut
F Cathode Clamp
Maintenance
25