Install The New Lamp - Christie cp2215 User Manual

Maintenance
g. With the lamp removed, visually inspect the reflector and clean if necessary.
8. Remove the new lamp from the protective case.
9. Loosen the cathode screw and remove the cathode nut from the lamp.

Install the New Lamp

1. Remove the tape from the ends of the protective case.
2. Remove the plastic packing material from the lamp.
3. Remove the cathode nut from the lamp before removing it from the case.
4. Hold the anode end of the new lamp in your left hand and angle it up through the hole in the back
of the reflector assembly. Insert your right index and middle finger through the back of the
80
Downloaded from ProjectorsManual.com Manuals
A Anode Terminal
B Anode Wire
C Reflector
D Cathode Screw
E Cathode Nut
F Cathode Clamp
Handle the lamp by the cathode/anode end shafts only, never the glass. DO NOT over-
tighten. DO NOT stress the glass in any way. Check leads. Make sure the anode (+) lead
between the lamp and igniter is well away from any projector metal, such as the reflector or
fire wall. Failure to comply could result in minor or moderate injury.
CP2215 User Manual
020-101225-01 Rev. 1 (01-2014)