NOTE: A complete set of instructions is available in the ZoneDirector Quick Start Guide (QSG).
Before restoring ZoneDirector to factory default settings, you should open and print out the
QSG pages. You can follow those instructions to set up ZoneDirector after restoring factory
defaults.
To reset your ZoneDirector to factory default settings
1. Go to Administer > Backup.
2. When the Backup/Restore page appears, look for Restore Factory Settings, and click the
button.
3. Owing to the drastic effect of this operation, one or more confirmation dialog boxes will
appear. Click OK to confirm this operation.
4. When this process begins, you will be logged out of the Web interface.
5. When the reset is complete, the Status LED is blinking green, indicating that the system is
in the "factory default" state. After you complete the Setup Wizard, the Status LED will be
steady green.
Figure 158. The Restore to Factory Settings section
Alternate Factory Default Reset Method
If you are unable to complete a software-based resetting of ZoneDirector, you can do the
following "hard" restore:
NOTE: Do not disconnect ZoneDirector from its power source until this procedure is complete.
Setting Administrator Preferences
Restoring ZoneDirector to Default Factory Settings
261