Ruckus Wireless ZoneDirector 1100 User Manual page 167

Verifying/Approving New APs
1. Go to Monitor > Access Points. The Access Points page appears, showing the first 15
access points that have been approved or are awaiting approval. If ZoneDirector is
managing more than 15 access points, the Show More button at the bottom of the list will
be active. To display more access points in the list, click Show More. When all access points
are displayed on the page, the Show More button disappears.
2. Review the Currently Managed APs table. See
• If the Configure > Access Points > Access Points Policies > Approval check box is
checked, all new APs should be listed in the table, and their Status should be
"Connected."
• If the Automatic AP Approval option is disabled, all new APs will be listed, but their
status will be "Approval Pending."
3. Under the Action column, click Allow
to "Connected," the new AP is activated and ready for use.
NOTE: Use "Map View" (on the Monitoring tab) to place the marker icons of any newly
approved APs. See "Evaluating and Optimizing Network Coverage"
information.
Figure 97. The Monitor > Access Points page
Adding New Access Points to the Network
Figure 97.
. After the status is changed from "Disconnected"
Managing Access Points
on page 198 for more
155