Set-Factory - Ruckus Wireless SmartCell Gateway 200 Command Line Interface Reference Manual

set-factory

To reset to factory settings of the controller system, use the following command:
ruckus# set-factory
CAUTION!
configuration settings, backup files, and cluster settings. Before resetting a node to
factory settings, Ruckus Wireless strongly recommends that you export all of the
backup files on the controller to an FTP server using either the web interface or CLI.
NOTE: For information on how to use the controller web interface to reset a node
to factory settings, see the SmartCell Gateway 200 Virtual SmartZone High-Scale
Quick Setup Guide.
Syntax Description
This command has no arguments or keywords.
Default
This command has no default settings.
Command Mode
Privileged
Example
ruckus# set-factory
setup
To setup the controller system, use the following command:
ruckus# setup
Syntax Description
This command has no arguments or keywords.
Default
This command has no default settings.
Command Mode
User
SCG200, vSZ-H and SZ300 Command Line Interface Reference Guide for SmartZone 3.5.1, 800-71515-001 Rev A
Resetting a node to factory settings will erase all of its system
System Commands
set-factory
574