Changing The Network Addressing - Ruckus Wireless ZoneDirector 1100 User Manual

Changing the Network Addressing

If you need to update the IP address and DNS server settings of ZoneDirector, follow the steps
outlined below.
CAUTION: As soon as the IP address has been changed (applied), you will be disconnected
from your Web interface connection to ZoneDirector. You can log into the Web interface again
by using the new IP address in your Web browser.
1. Go to Configure > System.
2. Review the Device IP Settings options.
Figure 23. The Device IP options
3. Select one of the following:
• Enable IPv6 Support: By default, ZoneDirector operates in IPv4 mode. If your network
uses IPv6, select Enable IPv6 Support and enter configuration settings for either IPv6
only or dual IPv4/IPv6 support. See
• Manual: If you select Manual, enter the correct information in the now-active fields (IP
Address, Netmask, and Gateway are required).
• DHCP: If you select DHCP, no further information is required.
4. Click Apply to save your settings. You will lose connection to ZoneDirector.
5. To log back into the Web interface, use the newly assigned IP address in your Web browser
or use the UPnP application to rediscover ZoneDirector.

Changing the Network Addressing

IPv6 Configuration below for more information.
Configuring System Settings
35