Ruckus Wireless ZoneDirector 1100 User Manual page 289

NOTE: If ZoneDirector is unable to determine the IP address of the wireless client that you
want to test (for example, if the wireless client is using a static IP address), the SpeedFlex link
for that client does not appear on the Currently Active Clients page.
6. Choose UDP or TCP from the Protocol drop-down list. Only one type of traffic can be tested
at a time.
7. If you are testing AP throughput, you have the option to test both Downlink and Uplink
throughput. Both options are selected by default. If you only want to test one of them, clear
the check box for the option that you do not want to test.
8. Click the Start button.
• If the target client does not have SpeedFlex installed, a message appears in the
ZoneDirector administrator's browser, informing you that the SpeedFlex tool has to be
installed and running on the client before the wireless performance test can continue.
Click the OK button on the message, download the appropriate SpeedFlex version
(Windows, Mac or Android) from http://<ZoneDirector-IP-Address>/perf,
and email it to the user, or instruct the user to go to http://<ZoneDirector-IP-
Address>/perf to download and install it. (See
Own Wireless Throughput"
the client, click Start again to continue with the wireless performance test.
A progress bar appears below the speedometer as SpeedFlex generates traffic to measure the
downlink or uplink throughput. One throughput test typically runs for 10-30 seconds. If you are
testing both Downlink and Uplink options, the two tests take about one minute to complete.
When the tests are complete, the results appear below the Start button. Downlink and uplink
throughput results are displayed along with packet loss percentages.
Figure 173. The SpeedFlex interface
Measuring Wireless Network Throughput with SpeedFlex
"Allowing Users to Measure Their
on page 280.) After SpeedFlex is installed and running on
Troubleshooting
277