Configuring System-Wide Guest Access Policy - Ruckus Wireless ZoneDirector 1100 User Manual

Figure 131. Create a Guest Access WLAN

Configuring System-Wide Guest Access Policy

The Enable Guest Access options enable the administrator to define the system-wide guest
access policy. You can require guests to validate their guest pass, accept terms of use, and be
redirected to a URL you specify.
1. Go to Configure > Guest Access. The Guest Access page appears.
2. Under Enable Guest Access, select the Authentication type to use:
• Use guest pass authentication: Redirect the user to a page requiring a valid guest pass
before allowing the user to use the guest WLAN.
• If you want multiple guests to be able to use the same guest pass simultaneously, select
the Allow multiple users to share a single guest pass check box.
• No authentication: Do not require redirection and guest pass validation.
3. Under Terms of Use, select the Show terms of use check box to require the guest user to
read and accept your terms of use prior to use. Type (or cut and paste) your terms of use
into the large text box.
4. Under Redirection, select one of the following radio buttons to use/not use redirection:
• Redirect to the URL that the user intends to visit: Allows the guest user to continue to
their destination without redirection.
• Redirect to the following URL: Redirect the user to a specified Web page (entered into
the text box) prior to forwarding them to their destination. When guest users land on
this page, they are shown the expiration time for their guest pass.
5. Click Apply to save your settings.
Managing Guest Access
Configuring Guest Access
217