Configuring System Settings
Changing the Network Addressing
IPv6 Configuration
ZoneDirector supports IPv6 and dual IPv4/IPv6 operation modes. If both IPv4 and IPv6 are used,
ZoneDirector will keep both IP addresses. Ruckus ZoneFlex APs operate in dual IPv4/v6 mode
by default, so you do not need to manually set the mode for each AP.
If you enable IPv6, you have the option to manually configure an IP address in IPv6 format (128
bits separated by colons instead of decimals) or to choose Auto Configuration. If you choose
Manual, you will need to enter IP Address, Prefix Length and Gateway.
Table 13. Default static IPv4 and IPv6 addresses
IPv4
IPv6
DNS Address can be configured manually or obtained automatically by the DHCPv6 client.
NOTE: If you switch from IPv4 to IPv6, you will need to manually change a number of settings
that may have previously been configured, such as Access Control Lists (ACLs), AAA server
addresses, Syslog server, SNMP trap receiver, etc.
When IPv6 is enabled, the other fields where IP addresses are entered (such as Additional
Management Interface) automatically change to allow entry of IPv6 format addresses, as shown
in
Figure
Note that some features are not supported when in IPv6 mode. Specifically, internal DHCP
server, LAN rogue AP detection, DHCPv6 vendor specific options, Aeroscout RFID tag detec-
tion, SSL certificate generation, UPnP, remote access to ZD, and L2TP and WISPr in standalone
APs are not supported when in IPv6 mode.
AP default IP address
192.168.0.1
fc00::1
24.
ZoneDirector default IP address
192.168.0.2
fc00::2
36