Configuring System Settings; System Configuration Overview; Changing The System Name - Ruckus Wireless ZoneDirector 1100 User Manual

Configuring System Settings

System Configuration Overview

System Configuration Overview

The majority of ZoneDirector's general system settings can be accessed from the Configure >
System page in the Web interface. A basic set of parameters is configured during the Setup
Wizard process. These parameters and others can be customized on this page.
NOTE: When making any changes in the Web interface, you must click Apply before you
navigate away from the page or your changes will not be saved.

Changing the System Name

When you first worked through the Setup Wizard, you were prompted for a network-recogniz-
able system name for ZoneDirector. If needed, you can change that name by following these
steps:
1. Go to Configure > System.
2. In System Name (under Identity), delete the text, and then type a new name.
The name should be between 6 and 32 characters in length, using letters, numbers,
underscores (_) and hyphens (-). Do not use spaces or other special characters. The first
character must be a letter. System names are case sensitive.
3. Click Apply to save your settings. The change goes into effect immediately.
Figure 22. The Identity section on the Configure > System page
34