Configuring System Settings
Setting the Country Code
Table 14. Channel Optimization settings for US Country Code
Setting
Optimize for Performance
Specifically, the channels available for AP use are the following:
•
Optimize for Compatibility: 36, 40, 44, 48, 149, 153, 157, 161, 165 (non-DFS channels)
•
Optimize for Interoperability: non-DFS channels plus channels 52, 56, 58, 60
•
Optimize for Performance: all DFS/non-DFS channels, including 100, 104, 108. 112, 116,
120, 124, 128, 132, 136, 140.
NOTE: If you are located in the United States and have a DFS-capable ZoneFlex AP that is
expected to serve as a Root AP (or eMAP), with a non-DFS-capable Mesh AP as its downlink,
you will need to set the Channel Optimization setting to "Optimize for Compatibility." This is
due to the DFS-capable AP's ability to use more channels than the non-DFS-capable APs, which
could result in the RAP choosing a channel that is not available to the MAP. Alternatively,
manually set the channel for the Root AP to one of the non-DFS channels. Specifically, choose
one of the following channels: 36, 40, 44, 48, 149, 153, 157, 161, 165.
The channels available for AP use are the following:
•
Optimize for Compatibility: 36, 40, 44, 48, 149, 153, 157, 161, 165 (non-DFS channels).
•
Optimize for Interoperability: non-DFS channels plus channels 52, 56, 58, 60.
•
Optimize for Performance: all DFS/non-DFS channels, including 100, 104, 108, 112, 116,
120, 124, 128, 132, 136, 140.
Channel Mode
Some countries restrict certain 5 GHz channels to indoor use only. For instance, Germany
restricts channels in the 5.15 GHz to 5.25 GHz band to indoor use. When ZoneFlex Outdoor
APs and Bridges with 5 GHz radios (ZoneFlex 7762, 7761-CM and 7731) are set to a country
code where these restrictions apply, the AP or Bridge can no longer be set to an indoor-only
channel and will no longer select from amongst a channel set that includes these indoor-only
channels when SmartSelect or Auto Channel selection is used, unless the administrator
configures the AP to allow use of these channels.
For instance, if the AP is installed in a challenging indoor environment such as a warehouse,
the administrator may want to allow the AP to use an indoor-only channel. These channels can
be enabled for use through the AP CLI or ZoneDirector Web interface by configuring Configure
> System > Country Code > Channel Mode and checking Allow indoor channels (allows
Description
ZoneFlex APs can use all available
DFS and non-DFS channels, without
regard for compatibility or
interoperability.
Use this setting when
You have only DFS-capable APs in
your network, you are not concerned
with DFS compatibility of client
devices, and you want to make the
maximum use of all possible available
channels.
48