Importing A Script - Ruckus Wireless ZoneDirector 1100 User Manual

1. The PPI:802.11-Common Header antenna signal and antenna noise fields of packets
transmitted by the AP contain the next-to-lowest byte and the lowest byte, respectively, of
the antenna pattern used to transmit the packet. On some APs, the pattern value may
contain more significant bits, which are not stored in this header. If the packet is 802.11n,
it will also contain the full antenna pattern value in the header described below.
2. The PPI:802.11n-MAC+PHY Header EVM-3 field of packets transmitted by the AP contains
the full antenna pattern used to transmit the packet (similar to above, except this 32-bit
field can accommodate the complete value).
3. The PPI:802.11n-MAC+PHY Header MAC Flags field's upper bits convey additional TX and
RX descriptor indicators described in the table below.
Table 38. Ruckus-defined indicators conveyed in MAC Flags
TX Indicator
Sounding (0=not; 1=yes)
TxBF (0=not applied; 1=yes)
Ness (#ext spatial streams)
STBC (0=not applied; 1=yes)
LDPC (0=not applied; 1=yes)
LDPC indicator valid
unassigned
RTS HTC TRQ
RTS HTC MRQ
RTS HTC MSI
RTS enabled
Calibrating
Limitation: The AP can report RX EVM values or the RX LDPC indicator, but not both. When
packet capture is invoked from the ZD UI, the software selects RX EVM values. Therefore, the
RX LDPC indicator is not reported, and the LDPC indicator valid bit will be zero. The RX LDPC
indicator is available when invoking packet capture from the AP command line interface.

Importing a Script

The Upload Scripts feature can be used to help Ruckus Support in diagnosing customer
network issues remotely by allowing the administrator to upload a Ruckus-created script to
ZoneDirector themselves. If instructed to do so by Ruckus Support, go to Administer >
Diagnostics > Import Scripts and click Choose File to upload a script to ZoneDirector.
Bit RX Indicator
31 Sounding (0=not; 1=yes)
30 unassigned
28-29 Ness (#ext spatial streams)
27 STBC (0=not applied; 1=yes)
26 LDPC (0=not applied; 1=yes)
25 LDPC indicator valid
24 unassigned
23 HW Upload Data
22 HW Upload Data Valid
20-21 HW Upload Data Type
19 unassigned
18 unassigned
Troubleshooting
Importing a Script
289