Ruckus Wireless ZoneDirector 1100 User Manual page 18

Introducing Ruckus Wireless ZoneDirector
ZoneDirector Physical Features
Buttons, Ports, and Connectors
Table 3 describes the buttons, ports and connectors on ZoneDirector 3000.
Table 3.
Label
Power
F/D
Reset
USB
Console
10/100/1000 Ethernet
Front Panel LEDs
Table 4 describes the LEDs on the front panel of ZoneDirector 3000.
Table 4.
LED Label
Power
Buttons, ports, and connectors on ZoneDirector 3000
ZoneDirector 3000 front panel LEDs
State
Green
Off
Meaning
(Located on the rear panel)
Press this button to power on ZoneDirector.
To reset ZoneDirector to factory default settings,
press the F/D button for at least five (5) seconds.
For more information, refer to
Default Reset Method"
WARNING: Resetting ZoneDirector to factory
default settings will erase all configuration
changes that you have made.
To restart ZoneDirector, press the Reset button
once for less than two seconds.
For Ruckus Wireless Support use only
RJ-45 port for accessing the ZoneDirector
command line interface.
Two auto negotiating 10/100/1000Mbps
Ethernet ports. For information on what the two
Ethernet LEDs indicate, refer to
Meaning
ZoneDirector is receiving power.
ZoneDirector is NOT receiving power.
If the power cable or adapter is
connected to a power source, verify
that the power cable is connected
properly to the power jack on the rear
panel of ZoneDirector.
"Alternate Factory
on page 261.
Table 4.
6