Ruckus Wireless ZoneDirector 1100 User Manual page 16

Introducing Ruckus Wireless ZoneDirector
ZoneDirector Physical Features
Table 1.
Label
Reset
Front Panel LEDs
Table 2 describes the LEDs on the front panel of ZoneDirector 1100.
Table 2.
LED Label
Power (embedded on
the Power button)
Status
Buttons, ports, and connectors on ZoneDirector 1100
Description
Use the Reset button to restart ZoneDirector or to reset it to
factory default settings.
• To restart ZoneDirector, press the Reset button once for
less than two seconds.
• To reset ZoneDirector to factory default settings, press and
hold the Reset button for at least five (5) seconds. For more
information, refer to
Method"
WARNING: Resetting ZoneDirector to factory default settings
will erase all configuration changes that you made.
ZoneDirector 1100 front panel LEDs
State
Solid Green
Off
Solid Green
Flashing Green
Red
Flashing Red
"Alternate Factory Default Reset
on page 261.
Meaning
ZoneDirector is receiving power.
ZoneDirector is NOT receiving power.
If the power cable or adapter is
connected to a power source, verify
that the power cable is connected
properly to the power jack on the rear
panel of ZoneDirector.
Normal state.
ZoneDirector has not yet been
configured. Log into the Web interface,
and then configure ZoneDirector using
the setup wizard.
ZoneDirector has shut down (but is still
connected to a power source).
ZoneDirector is starting up or shutting
down.
4