Using The Map View Tools - Ruckus Wireless ZoneDirector 1100 User Manual

Using the Map View Tools

If your worksite floorplan has been scanned in and mapped with APs, the Map View will display
a graphical image of your physical Ruckus network AP distribution.
Figure 114. Elements on the Map View
1
2
3
4
5
There are a number of helpful features built into the Map View, as noted here and marked in
the above illustration:
1. Map drop-down list: Select the floorplan to view from the Map drop-down list.
2. Coverage and Show Rogue APs box: For Coverage, selecting 2.4 GHz enables a signal
strength view of your placed 2.4 GHz APs. Selecting 5 GHz displays the signal coverage of
5 GHz radios. Selecting either 2.4 or 5 GHz opens the Signal (%) legend on the right side
of the Map View. See item number 8 below for the description of the Signal%. For Show
Rogue APs, selecting Yes displays the detected rogue APs in the floorplan.
3. Unplaced APs area: As noted in Importing a Map View Floorplan Image, when you first
open the Map View, newly placed APs appear in this area. If they are approved for use (see
"Adding New Access Points to the Network"
correct location in the floorplan. Unplaced APs are available across all of the floor plans you
upload. Thus, you can toggle between maps (see number 1) and place each AP on the
appropriate map. For the various AP icon types, see
4. Access Points, Rogue APs, and Clients box: This lower left corner box displays the number
of active APs, any rogue (unapproved or illegitimate) APs, and all associated clients.
Monitoring Your Wireless Network
6
on page 154), you can drag them into the
"AP Icons"

Using the Map View Tools

8
11
12
on page 186.
185
7
9
10