Cisco ONS 15454 Troubleshooting Manual page 537

Chapter 4 Error Messages
Table 4-1 Error Messages (continued)
Error Warning
ID Error Warning Message
EID-6254 SDH mode does not support timing references.
EID-6255 Only DS1 interfaces with ESF line types support timing
references.
EID-6256 sendDoNotUse and sendDoNotUseFF are mutually exclusive.
EID-6257 The termination is already in use.
EID-6258 The side is carrying services or traffic.
EID-6259 A pluggable module on Port 22 remains unmanaged.
EID-6260 You cannot delete this port.
There was a severe architectural error related to the index of the
pluggable trunk port object.
Please contact technical support for assistance.
EID-6261 This is not a valid VLAN ID. The VLAN database is empty.
EID-6263 The equipment requires two slots.
EID-6264 The patchcord is duplicated.
EID-6265 The wavelength is in use by an OCH trail, a virtual link, or an
internal patchcord.
EID-6266 The card cannot be changed because the port has not been
provisioned.
EID-6267 Each port can have a maximum of 8 MAC addresses.
EID-6268 This server trail does not have a valid start or end.
EID-6269 The maximum number of server trails is 3743.
EID-6270 A unique server trail ID could not be allocated.
EID-6271 The server trail already exists.
EID-6272 The server trail size must not exceed the port bandwidth.
EID-6273 An OCH Trail circuit is active on the trunk port.
To modify the ITU-T G.709 parameter, the circuit must be out
of service.
EID-6274 Unable to restore this database:
The software version cannot be obtained from the node. Please
try again.
EID-6275 You cannot change this parameter.
The port is part of an active circuit.
EID-6276 APC is disabled. APC Correction Skipped. Override cannot be
performed.
November 2009
Description
Timing reference is not supported by SDH
mode.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
The user adds a row without a valid VLAN
database loaded.
The user provisions a double footprint card
in a single slot.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Refer to the error message text.
Certain parameters like Port Rate and
Admin State cannot be changed when the
port is part is part of an active circuit.
Delete all the circuits on the port before
changing admin state of the port.
Refer to the error message text.
Cisco ONS 15454 Troubleshooting Guide, R8.5
4-49